Chesapeake 16LT Kayak: Part 13: Wet sanding

General, Woodworking

I did some wet sanding on the kayak after the first coat. The directions say to use 400 grit, but I wet sanded the first two coats with 320, and then switched to 400 for the next two coats.

I grabbed my Go Pro Hero 5 Black and set it up to do a time lapse while I sanded.

I edited the footage using my 27″ iMac using Final Cut Pro X. It chugged a bit, as there were a TON of pictures to process, but it wasn’t too hard to create a short little video.

Griffin Hammond has created a great tutorial on how to do the editing: How to Edit a Time Lapse (in Final Cut Pro X)

Previous in Chesapeake 16LT Kayak
Chesapeake 16LT Kayak Part 12: Starting the finishing process
Next in Chesapeake 16LT Kayak
Chesapeake 16LT Kayak: Part 14 - Finished.
0 0 votes
Article Rating
Notify of
Inline Feedbacks
View all comments

As an Amazon Associate I earn from qualifying purchases.

(c) 2008-2021 Corbin Dunn

Privacy Policy

Subscribe to RSS feeds for entries.

63 queries. 0.827 seconds.

Log in