All posts in May, 2023
Avid CNC ATC Post Processor for Fusion 360
If you are using an Automatic Tool Changer (ATC) with an Avid CNC then you have to customize or install a new post processor to make it work properly in Fusion 360. UPDATE: the current... [read more]
May
27
2023
Avid CNC ATC Post Processor Setup – Vectric VCarve / Vectric Aspire
If you are using an Automatic Tool Changer (ATC) with an Avid CNC (Mach 4 or Centroid), then you need to customize the post processor for Vectric. The one provided by Avid is not right!... [read more]
May
21
2023
Video: Mach 4 Setup for an ATC
In one of my last posts, I discussed how I setup the hardware for my ATC on my Avid CNC. This video describes the software side of things. I’ve been working on this software for... [read more]
May
19
2023
Video: How to Make an ATC Tool Rack
I needed a tool rack for my HITECO ATC spindle on my Avid CNC machine. I experimented with 3D printing some holders, but I felt like they were too weak. So, I ended up machining... [read more]
May
9
2023
How to Setup an Automatic Tool Changer (ATC) on an Avid CNC using Mach 4
Video link: ATC Setup on Avid CNC This is a companion article for the above video where I talk about setting up an Automatic Tool Changer (ATC) on a CNC machine. For the Mach 4... [read more]
May
3
2023
As an Amazon Associate I earn from qualifying purchases.
(c) 2008-2024 Corbin Dunn
Subscribe to RSS feeds for entries.
45 queries. 0.178 seconds.