Master Bathroom Cabinets; Drawer Faces and Doors

DIY Home Remodeling, Woodworking

Still working on stuff.

Playing with stains; left side is 1/2 cherry ply, right is cherry wood. Bottom has a maple gel stain, top has pennsylvania cherry gel stain.

IMG_9545.JPG

Cutting all the face pieces to 1 5/8″:

IMG_9546.JPG

1/2″ wide groove in the center of the 3/4″ piece of wood:

IMG_9548.JPG

I then put a 45 on the inside, and a V groove with the router table 1/2″ from the outside:

IMG_9551.JPG

I tanned the boards outside for about ~5-10 minutes to get them a little brown before gluing up. The inside cherry ply is still a little pinker.

It was tricky gluing them together to keep the miters straight; the first two were a bit off, so I just screwed a jig to my table and all the rest were dead straight:

IMG_9560.JPG

The big cabinet door:

IMG_9566.JPG

The 45’s have no spline or support; I will probably need to cut some slots and miter in a spline to make them stronger.

Here’s a few of the small drawer faces:

IMG_9563.JPG



Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments

Subscribe to new posts:

You'll get an email whenever a I publish a new post to my blog and nothing more. -- Corbin

As an Amazon Associate I earn from qualifying purchases.

(c) 2008-2024 Corbin Dunn

Privacy Policy

Subscribe to RSS feeds for entries.

70 queries. 0.183 seconds.

Log in