Master Bathroom Remodel: Drawers Finished

DIY Home Remodeling

I finished my drawers; sprayed 4 coats of Target Coatings Water based lacquer on them. (EmTech 6000). It took a whole gallon to do them all..and ran out right at the end.

These are mainly notes for myself, as I wish I had made notes when I did my last set of drawers. I would first spray the bottoms on edge, like below:

IMG_9664.JPG

Then drop them into the normal position after they dried and do the rest. I put on two coats, then sanded with 220 to get any bumps off. The bottoms of the smaller drawers got a little too thick on the bottom sideā€¦and it is slightly more yellow than I wanted, but still good enough. Four coats seems adequate; more would have too much buildup.

IMG_9668.JPG

My Mini-mate HVLP pump/compressor.

IMG_9669.JPG



Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments

Subscribe to new posts:

You'll get an email whenever a I publish a new post to my blog and nothing more. -- Corbin

As an Amazon Associate I earn from qualifying purchases.

(c) 2008-2024 Corbin Dunn

Privacy Policy

Subscribe to RSS feeds for entries.

73 queries. 0.400 seconds.

Log in