Corbin Dunn
Redwood Monkey

The Circular Treehouse – Updated Plans

Treehouses

I decided to redo my “special event” treehouse concept. I wanted something far enough out in front of the trees to suffice as a proper area to stand for the ceremony, and the typical umbrella treehouse design seemed like a good idea, so I went with it. This design can be seen in some old treehouse books, such as Nelson’s “Home Tree Home” (the basic treehouse building bible — I used it when I built my last big treehouse about 10 years ago).

Wedding_treehouse_knee_braces.jpg

I’m opting for a half-round treehouse for several reasons:

1. Cost/wood — a lot of the wood I’m using is reclaimed from when my deck was built (they are 2×8’s used to form the cement retaining wall)

2. Time. I want to get it done sooner than later.

3. I don’t want to kill the tree. The diameter isn’t that large, and I’m afraid that sticking a ton of lag bolts into the tree will kill it if I go entirely around the tree. Even with lag bolts half way around the tree could potentially get damaged, but, I don’t think anything will happen since redwoods are *very* resilient. These redwoods have survived a fire that happened a long time ago (at least over 35 years ago, since the main house has been there that long. )

I’m a little late at writing my blog entry..since I’ve already got a start on the treehouse, but the next steps were to fabricate the treehouse brackets. That’ll be the next entry..

Previous in Treehouses
Tree Top Builders
Next in Treehouses
The Circular Treehouse - Bracket Fabrication

Leave a Reply

avatar
500
  Subscribe  
Notify of

(c) 2008-2018 Corbin Dunn

Privacy Policy

Subscribe to RSS feeds for entries.

65 queries. 1.351 seconds.

Log in