Workshop Project 2021

Workshop and Woodshop Design – The Truckee Workshop Garage – Part 1

We live near Lake Tahoe, California in a town called Truckee. When we bought the house it didn’t have a garage, and I was perfectly fine with that. I knew I wanted to have a... [read more]
Woodworking

Getting Plans – The Truckee Workshop Garage – Part 2

Previously, I discussed some of the initial workshop layout in part 1. The Truckee area gets a lot of snow which limits the construction season. This greatly affected my decision on how to get the... [read more]
Woodworking

The Overall Process – The Truckee Workshop Garage Part 3

Check out my previous article where I discussed how I got plans for my workshop. I want to go back a bit and discuss the overall top level process for getting an owner-builder permit. When... [read more]
Woodworking

Site Prep – The Truckee Workshop Garage Part 4

At this point I was waiting for my permit application to be reviewed, but I could start doing some general site preparation. The site had a huge pile of construction wood from when the house... [read more]
Woodworking

Excavation – The Truckee Workshop Garage Part 5

I hired Bobby Jones Concrete to do both my excavation and concrete foundation. Initially I had contacted them to just do the concrete, but they mentioned they also did digging. It was easier for me... [read more]
Woodworking

Making a Workshop Slab Foundation – The Truckee Workshop Part 6

In the previous post I talked about excavation. Jump back there if you missed it, or check out all the posts for my Workshop Project 2021. Once the digging was done the guys from Bobby... [read more]
Woodworking

Wood Package Delivery – The Truckee Workshop Part 7

The slab was done and it was now time to get the wood package from Pacific Modern Homes Inc (PMHI) via my dealer California Precut Homes (CPH). Once my plans were approved by the county... [read more]
Woodworking

Framing a Woodshop – The Truckee Workshop Part 8

Once the wood was delivered it was go time for construction. I needed to get it roofed before winter started rolling in, and the pre-framed walls gave me a pretty good head start, but this... [read more]
Woodworking

Steel Posts and the Ridge Beam Install – Truckee Workshop Part 9

The outer shell of the structure went up pretty quickly, and it was soon time to get the main ridge beam installed and begin roof sheathing. My plans called for two steel posts supporting three... [read more]
Woodworking

Ceiling and Roof Construction – Truckee Workshop Part 10

In the last post I talked about how we go the steel posts and main beam installed for my garage/shop project. I was working really hard to get the roof on and keep everything dry,... [read more]
Woodworking

Exterior Prep and Wrap – Truckee Workshop Part 11

In the last post I wrote about how me and the crew got the building semi-roofed; the OSB sheathing covered most stuff and would keep out most rain. It did rain a bit and test... [read more]
Woodworking

Exterior Siding & Roofing – Truckee Workshop Part 12

After wrapping the house the next step was to get it sealed for winter. Check out the previous post where I did that work: Wrapping the Workshop. The roofers came and put on the roof... [read more]
Woodworking

As an Amazon Associate I earn from qualifying purchases.

(c) 2008-2022 Corbin Dunn

Privacy Policy

Subscribe to RSS feeds for entries.

41 queries. 0.514 seconds.

Log in