LED Cyr Wheel v3: “rolling” the wheel

Circus/Cyr Wheel

Fresh rolled wheel:

IMG 5942

 

Marking off the circumference with a flexible tape measure:

IMG 5943

After cutting it into a 5 piece wheel:

IMG 5944

Some of the curves where a little under-bent, so I rolled a few through the bender again to get them aligned a little more to the template.

Turning the 3/16” sidewall steel inserts (1.25” OD) down a bit. I went to 1.240”. I’ll see how well that works tomorrow…

IMG 5953

 

.. the ’40 ford is watching me.

 

 



Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments

Subscribe to new posts:

You'll get an email whenever a I publish a new post to my blog and nothing more. -- Corbin

As an Amazon Associate I earn from qualifying purchases.

(c) 2008-2024 Corbin Dunn

Privacy Policy

Subscribe to RSS feeds for entries.

73 queries. 0.439 seconds.

Log in